Casio DJ-120D plus - Page 59

— 56 —
*
1
Press the c key before the step you want to correct.
*
2
The CRT (CORRECT) indicator is on the display while Calculation Memory
editing is enabled.
*
3
Note that you can only edit values and command key operations (+, -, *,
/). You can edit only one step.
*
4
After you are finished making the changes you want, press the c key again.
*
5
Scroll to the last step to check the new result.
*
6
The result is always produced by the calculation. You cannot change it by
inputting a value.
• You can make as many changes as you want, as long as you press
c once to start the editing operation and then once again to end
the editing operation. Do not forget to press c to exit editing after
making the changes you want.
• When you edit the contents of a calculation, the rounding and decimal
place settings in effect when you make the changes affects all steps
stored in Calculation Memory.
• If an error occurs while you are inputting a calculation or editing a
calculation, all the steps are cleared from Calculation Memory and
cannot be reviewed.
• Calculation speed depends on the number of steps accumulated in
Calculation Memory.
*
1
Presione la tecla c antes del paso que desea corregir.
*
2
El indicador CRT (corregir) se encuentra sobre la presentación mientras la
edición de memoria de cálculo se encuentra habilitada.
*
3
Tenga en cuenta que solamente puede editar valores y operaciones de tecla
de mando (+, -, *, /). Sólo se podrá editar un paso.
c
5c
P
P
c
3c
P
P
CRT
REV
REV
REV
CRT
REV
REV
REV
002
10.
002
5.
003
5.
004
2.
004
2.
004
3.
005
5.
006
6.
*
6
*
5
*
3
'
'
(
)
)
)
=
=