256
APPENDIX
Display language setting
screen appears when the
camera is turned on.
1) You did not configure initial settings after purchasing the camera or the battery may have been left with
a dead battery. Check the camera setup (pages 11, 193).
2) There may be a problem with the camera’s built-in memory management area. If this is the case,
perform the reset operation to initialize the camera’s setup (page 143). After that, configure each setting.
If the language selection screen does not re-appear when you turn the camera on, it means that the
camera’s built-in memory management area has been restored.
If the same message appears after you turn power back on, contact your retailer or a CASIO service
center.
Problem Possible Causes and Action
To Next Page
Loading...
