3. Keep pressing (C) until the setting you
want to change is flashing.
●
Each press of (C) moves the flashing to
the next setting in the sequence shown
below.
Summer time
Home City
Minutes
Hours
Seconds
Day
Month
Ye a r
12/24-hour timekeeping
Illumination duration
4. Configure the date and time settings.
●
To reset the seconds to 00: Press (D).
1 is added to the minutes when the
current count is between 30 and 59
seconds.
●
For all the other settings, use (B) and (D)
to change the flashing setting.
Holding down (B) or (D) scrolls through
settings at high speed.
5.
Repeat steps 3 and 4 to select time and
date settings.
6. Press (A) to complete the setting
operation.
Note
●
If you do not perform any operation for
two or three minutes while the setting
screen is displayed, the watch
automatically returns to the
Timekeeping Mode.
●
Switching between 12-hour and 24-
hour Timekeeping
You can specify either 12-hour format or 24-
hour format for the time display.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least three seconds.
Release the button when the city code
starts to flash.
3. Press (C) twice.
This causes [12H] or [24H] to flash on the
display.
4. Press (D) to select [12H] (12-hour
timekeeping) or [24H] (24-hour
timekeeping).
24-hour
timekeeping
12-hour
timekeeping
5. Press (A) to complete the setting
operation.
Note
●
If you do not perform any operation for
two or three minutes while the setting
screen is displayed, the watch
automatically returns to the
Timekeeping Mode.
Watch Operation Guide 5715
8
To Next Page
Loading...
