Making Calls
1
Receiving Calls
■
Calling by entering a telephone number
2
2
■
Calling from the call history
3
2
Tap the person to call.
3
■
Calling someone in your contacts
Infrared Communications
■
To send contacts by infrared communications
■
To receive data by infrared communications
■
Importing contacts
■
Exporting contacts
A subscription for LTE NET is required to use E-mail (@ezweb.ne.jp).
If you did not subscribe when purchasing the phone, contact an au shop or Customer Service Center.
E-mail (@ezweb.ne.jp) is a service which enables you to exchange e-mails.
E-mail Settings
Saving Battery Power
1
2
Activating an eco mode can reduce battery consumption.
You can choose from the following three types of eco modes.
You can receive contacts in vCard format. You can also receive images in JPEG, GIF,
PNG, and WEBP formats. Still images received can be viewed in the gallery.
* Some data cannot be registered, played, or saved, even if it is received.
3
1
Confirm the content
displayed, and then
tap [
接続する
]
(Connect).
2 3
Confirm the e-mail
address, and then tap
[
閉じる
] (Close).
■
Initial settings for your e-mail address
The initial settings screen is displayed when you first start E-mail after purchase.
Your e-mail address is determined automatically by making initial settings. You can change
the e-mail address determined in initial settings.
* Be sure to make initial settings for E-mail (@ezweb.ne.jp) in Japan.
■
Changing your e-mail address
You can change the e-mail address determined in initial settings.
Tap [Settings].
Tap [eco mode].
Tap [eco mode].
4 5
Infrared communications on the product complies with IrMC version 1.1. However,
data may not be sent or received correctly depending on the function, even if the
other device complies with IrMC version 1.1.
Confirm the content
displayed, and then
tap [
接続する
]
(Connect).
9 10
Tap [E
メールアドレス
の変更
] (Change e-mail
address).
5
6
Enter your e-mail
address, and then
tap [
送信
] (Send).
8
Tap [OK].
Confirm the content
displayed, and then
tap [
承諾する
]
(Agree).
7
Enter your security
code, and then tap
[
送信
] (Send).
1
Tap
M
.
2 3
Tap [Other settings].Tap [E-mail settings].
4
To confirm your current e-mail address, perform procedures to , and then tap [E-mail information].
1
1
6
Backing Up E-mails
1
2
You can back up e-mails on the phone. If you have installed a microSD memory card,
you can save the backup to that microSD memory card.
3
Tap
M
.
Tap [E-mail settings].
Tap [Backup/Restore].
4
Tap [Backup].
5
Tap [OK].
Importing/Exporting Contacts
You can import to the product vCard files for contacts stored on a microSD memory card.
* Some contacts may not be importable due to issues with the vCard file. Also, some details may not be
importable.
4
If multiple vCard files are saved on the microSD memory card, a screen to select the
method of importing the vCard file will be displayed after procedure .
You cannot use “Import from storage” or “Export to storage” if a microSD memory card is
not installed in the phone.
Tap [Import from
storage].
You can save your contacts to a microSD memory card as a vCard file.
Auto
“Original eco mode” or “Full eco mode” will be activated
according to the conditions set for “Auto” settings.
Original eco mode
Eco mode will operate according to “Original eco mode” settings.
Full eco mode
Eco mode will operate with battery consumption minimized.
Tap [Auto],
[Original eco mode],
or [Full eco mode].
1
2 3
If an authentication
password screen is
displayed, enter the
same authentication
password (four-digit
number) as the sending
party, and then tap [OK].
Tap [Receive data]. Tap [OK], and then point the
infrared port to the phone you
wish to exchange data with.
4 5
An explanation will be
displayed. Confirm the
content displayed, and
then tap [OK].
•
Backed up e-mails are stored in the memory on the phone (“/mnt/sdcard/private/au/
email/BU” folder). If you have installed a microSD memory card, e-mails will be stored
on the microSD memory card (“/mnt/sdcard/external_sd/private/au/email/BU” folder).
•
To import backed up e-mails, tap [Restore mails.] in procedure .
5
If a selection screen is displayed, tap
the account to register the contact to.
Tap .
Tap .
4
1 3
Enter a telephone
number, and then
tap .
Tap next to the
person to call.
■
To accept a call
1
The call is accepted.
2
To hang up, tap .
3
■
To reject a call
1
Ringing stops, the call ends, and the other
party will be notified by voice guidance.
2
1
2 3
Tap [Import/export
contacts].
On the home screen,
tap [
基本ツール
]
(Basic tools).
Tap [People].
Tap [People].
1
2 3
Tap
M
.
Tap [Import/export].
On the home screen, tap
[
基本ツール
] (Basic tools).
Tap [Share visible contacts].
4
Tap [IrDA].
5
Tap [OK].
6
9
Enter the same authentication
password (four-digit number)
as the receiving party, and
then tap [OK].
Tap [OK].
Tap [OK].
1
2 3
6
Tap
M
.
Tap [Import/export].
Tap [Export to storage].
4 5
On the home screen,
tap [
基本ツール
]
(Basic tools).
Tap [OK].
7
8
Tap on the
incoming call screen.
Tap on the home
screen, and then
tap .
Tap on the home
screen.
Tap on the home
screen.
Tap on the home
screen.
Tap [People].
Tap [Add all] or
[Replace all].
6
Tap on the home
screen, and then
tap .
Tap on the home
screen, and then
tap .
On the home screen,
tap [
基本ツール
]
(Basic tools).
On the home screen,
tap [
基本ツール
]
(Basic tools).
PC-mail settings
You can use a mail address other than one used for E-mail (@ezweb.ne.jp).
When you use PC-mail for the first time, set by the following operations.
On the home screen, tap
→
[PC-mail]
→
Enter a mail address
and password
→
[Next]
→
Set frequency to check the inbox
→
[Next]
→
Enter an account name and display name
→
[Next]
* For details, refer to the “Instruction Manual” app (in Japanese).
Tap on the
incoming call screen.
• If you receive a call while the screen is locked, tap
/
on the incoming call
screen twice.
• If the Answering Service* is activated or “Forward on no-reply” is set for the Call
Forwarding Service, Answering Service* or Call Forwarding Service has priority
even if you attempt to reject the call.
* Answering Service EX is a paid option service.
To Previous Page
Loading...
