Casio QA-300 - Time Functions; Setting Current Time and Date

=
¢ Even if you plan only to reset the seconds count to 00, be sure to input the hour and
minutes first.
*lf you want to clear your input during the above procedure, press (C).
¢ if you generate an error (“E” indicator) in the above procedure (by inputting 65 for
the minutes, for example), press (C) to clear it.
* To interrupt the time and date setting procedure at any point, press @. .
* Note that the clock is designed to change from February 28 to March 1, without mak-
ing allowance for leap year. Be sure to correct the date during leap years.
*The anaiog timepiece is automatically synchronized with the digital timepiece. You
do not need to make any settings for the analog timepiece.
* You can select whether or not to display a second hand on the analog timepiece.
At any point between steps 2 and 8 in the above procedure, press the 64) key to switch
-between display and non-display of the second hand. ;
@ Automatic Timekeeping Mode Display _ . : 83
If you do not perform any operation on the calculator for about six minutes, it automati-
cally switches to display of the current time. Note that calculation memory contents
are retained when this happens.
analy
arm
and
Hourly
Time
Signal
t
r
sounds
for
about
20
seconds
each
date
at
the
prese
d,
you
can
stop
it
by
pressing
any
key.
With
the
3/Using
the
Al
After
you
set
an
alarm,
a
buzze
time.
Once
the
alarm
starts
to
soun
hourly
time
signal,
the
calculator
beeps
twice
at
the
top
of
each
hour.
Does not
Does
not
Sounds
Hourly
Time
Does
not
Does
not
[sounes
|
sounes
Signal
sound
.
sound
WTo
Set
the
Alarm
Time
Example:
To
set
7:30
AM.
1.
Press
Gam)
to
display
the
current
alarm
setting.