Casio SF-4300B - About communications parameters

72
PART 6 Data Communications
3. Press 3 to select SET UP PAR.
#KSET UP PAR, sack
PARITY E O R
BIT LENGTH fi 8
BPS 4900 RBM
The
highlighted
items
on
the
display
are
the
parameters
that
are
currently
set.
The PARITY parameter is flashing because it is sefected.
Use
the
A
and
V
cursor
keys
to
change
the
selected
parameter
on
the
dispiay.
Use
the
<]
and
[>
cursor
keys
to
change
the
highlighted
setting
of
the
currently selected parameter.
When
the
parameters
are
set
the
way
you
want
them,
press
SET
fo
store
|
them
in
memory.
|
|
l
4,
5.
6.
About communications parameters...
Communications
parameters
make
it
possible
for
two
communicating
units
to
understand
each
other.
The
following
explanations
are
provided
for
your
information
only.
The
only
thing
you
need
to
remember
is
that
the
param-
eters
of
the
send
unit
and
the
receive
unit
must
be
identical.
Otherwise
you
will
not
be
able
to
transfer
data
successfully.
Parity’
Parity is used for error detection during data exchanges. You can set the
SF Unit parity as even (E), odd (0), or none {N).
Bit Length
The
bit
length
parameter
states
how
many
bits
are
to
be
used
for
each
character. You can set the SF Unit bit length as 7 bits or 8 bits.
BPS
The letters “BPS” stand for “bits per second,” and this setting represents
the
speed
at
which
data
is
sent.
The
SF
Unit
lets
you
set
a
speed
of
either
4800 or 9600.
em
Setting Up for Data Communications eels
To set up the SF Unit to receive data
1,
While an initial screen is displayed, press FUNC twice to display the second
function menu.
Youcan perform the above operation while the intial screen of the Telephone
Directory, Memo Mode, Schedule Keeper, Calendar, Reminder is displayed.
If you want the received data to be stored in the secret area, you should
also enter the secret area at this point. If you are in the open area on the
receiving unit, received data is stored into the open area.
Press 4 to select DATA COMM.
Press 2 to select RECEIVE.
Coreg RECEIVE OK
ATA +0 stop
ae PRESS<ESC)
This message indicates that the receive unit is standing by for data. Perform
the required procedures to start sending data from another SF Unit (see
owner's manual for details) or a personal computer (see the Interface Unit
manual for details).
To abort the receive operation at any time, press ESC.
This procedure is the same regardless of whether the data is received from
another SF Unit or from a personal computer.
The display changes to the following once the SF Unit starts receiving data.
RECEIVING
foe TENS
Receive data
item count
TO_STOP
Be) PRESSCESC)
The number of data items received is counted on the display.
If an error occurs during the receive operation, the message “TRANSMIT
ERROR!” appears on the display. Press ESC to clear the error message.
Received data is added to the data already stored in memary. If the memory
becomes full during the receive operation, the message “MEMORY FULL!"
appears and data transfer stops. Press ESC to clear the error message.