6.3 Defrost
The device automatically defrosts. Condensated water will be collected in a tray and
will automatically evaporate by compressor heat.
6.4 Moving the appliance
Turn off the appliance first and then unplug the unit from the wall outlet.
Remove all content. Shurely tape down all lose items inside your appliance.
Tape drawers shut. Fix the drawer with tape. The appliance may be title by a max
angle of 45 °, otherwise the cooling system can be damaged..
Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
6.5 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry
out any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
6.6 Fault indications and rectification of faults
The following table assists in localizing and rectifying minor faults.
Your device is not cold enough or it
does not reach the adjusted
temperature. Compressor does not
stop to work.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often. The door is not closed
completely. The door seal does not seal properly.
The device does not have the correct clearance.
Device is over filled.