objects. Cutting into a nail can cause the
bit and the tool to jump and damage the
bit.
Never hold the workpiece in one
hand and the tool in the other hand
when in use.
Never place hands near or below
cutting surface.
Always wear safety goggles and dust
mask. Use only in well ventilated
area.
Never touch the bit during or
immediately after the use. After use
the bit is too hot to be touched by bare
hands.
Never use bits that have a cutting
diameter greater than the opening in
the base.
WARNING Some dust created
by power sanding, sawing, grinding,
drilling, and other construction
activities contains chemicals known
to cause cancer, birth defects or
other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks
• and cement and other masonry
products, and
• Arsenic and chromium from
chemically-treated lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to
these chemicals: work in a well-ventilated
area, and work with approved safety
equipment, such as those dust masks
that are specially designed to filter out
microscopic particles.
Using personal safety devices and
working in safe environment reduces risk
of injury. After changing the bits or
making any adjustments, make sure
the collet nut and any other
adjustment devices are securely
tightened. Loose adjustment device can
unexpectedly shift, causing loss of
control, loose rotating components will be
violently thrown. Never start the tool
when the bit is engaged in the stock.
The bit cutting edge may grab the stock
causing loss of control of the cutter. The
direction of feeding the bit into the stock
is very important and it relates to the
To Next Page
Loading...