The dishes were not
loaded correctly .
See not es in " Loadin g the Dishwasher Baskets ".
Select a more intensive prog ramme.
See" Wash Cycle Table ."
Use mo re detergent, or change your detergent.
Rearrange the items so that the sp ay can rotate freely.r
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms".
r
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Use a mild abrasive cleaner to eliminate those marks.
Re-loading t he dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not em p ty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once t
he dishes are barely warm to the touch. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
In short program the washing t emperature is lower.
This al so lowers cleaning performance. Choose
a prog ram with a long washing time.
Water drainage is more d ifficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
The programme was
not powerful enough.
Not enough detergent
was d ispensed.
Items are blocking
the path of sp ay arms.r
The filter combination
inthebaseofwash
cabinet is not clean or
is not correctly fitted.
This may cause
the sp ay arm jets
to get blocked.
r
Combination of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dishes.
Dishes block
detergent cups.
Improper loading
Too little rinse -aid
Dishes are remov ed
too soon
Wrong program
has bee n selected
Use o f cutlery with
a low-quality coa ting
Tap is not opened, or water intake is restricted,or water pressure
is too low.
Some element of dishwasher leaks.
Longer inlet time.
Overfilled.
When some malfunctions come on, the appliance will display error codes to warn you:
If ove rflow occurs, turn of f the main water supp ly before calling a service.
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher .
The light flicker fleetlyrapid
The light flicker fleetly
ECO
To Next Page
Loading...
