With each wash cycle.
Compartment
For prog ramme s with pre-wash only.
(Follow the user instr uctions!)
Ele ctric indicator on control panel (if provided).
Check t he rinse aid level
(On models with water softener system only.)
Electric indicator on control p anel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt i nto
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Close the door, turn on the water tap. The machine will start working after about 10 second s.
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload t he baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 minutes) b efore unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower basket.
Changing the programme
Addforgottendishesinthe
dishwasher.
Scrape off any large amount of leftover food. Softe n remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Press the Programme button until the selected pr ogramm e lights up.
( See the section entitled Operationg instruction )“”
When t he working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON/OFF button.
If the appliance is switched
off during a wash cycle.
Op en th e door c arefully.
Hot steam may escape
wh en the door is opene d!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Press the On/O ff button to switch on the applianc e, Open the door.
1.Open the door a little to stop the dishwasher.
2.After the spray arms stop working, you can open the door completely.
3.Add the forgotten dishes.
4.Close t he door, the dishwasher will s tar t running again after 1 0 seconds.
For detailed operating method read the correspo nding content on the instruction manual.
1.A running cycle can only be modified if it has b een running for a short tim e. Otherwise the detergent
m ay have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. O pen the door a little to stop the washing , then press the Program button for more than 3 seconds to
cancel the running programme.
3. Select a new prog ramme, then c lose the door. The machine will restart after about 10 second s.
A
B
C
To Next Page
Loading...
