30
Fitting the appliance
Important
> The adjacent piece or furniture or cupboard and all the materials used
in the installation must resist a minimum temperature increase of 85 ºC
above the ambient temperature during use of the appliance.
> Certain types of vinyl or laminated kitchen furniture are particularly
susceptible to damage due to decolouration at temperatures below those
indicated.
> If the appliance is installed without paying attention to this temperature
limit or if it is placed less than 4 mm from the adjacent cupboards, liability
will belong to the owner.
Installation Notes
1. The oven has to be installed in a standard gap of 600 mm, as indicated
in Fig.5, whether under a hob or in a column.
2. On inserting the oven in a column, it is essential in order to ensure
there is enough ventilation, to remove the rear panel of the furniture
and have an opening of at least 85 – 90 mm as indicated in Fig.5.
3. Check that the oven has been xed securely in the housing. Fixing the
oven into the cupboard is done using 4 screws. One in each corner of
the oven door frame.
Installation
Appendix...
GB IE
To Next Page
Loading...
