Caterham SEVEN 620R - User Manual

To Next Page

CATERHAM SEVEN 620R # 21307

Package contents:

 4x Warm White Dot Lights (with 30cm cable)

 6x Warm White Dot Lights (with 15 cm cable)

 1x 12-port Expansion Board

 1x Flat Battery Pack (2x CR2032 Batteries Required)

Extra LEGO Pieces

 3x LEGO Trans Red 1x1 plates

 3x LEGO Trans Clear 1x1 plates

Note:

Place wires on the surface or under the LEGO building blocks.

The wire can be place between the building blocks or under the block, but they should be placed

between the studs correctly.

Insert the connectors to the ports.

Be careful when you are operating, there’s only one correct way to insert, make sure the expansion

board is upward, find the soldered “=” sign on the left of the port. When you are inserting, the side

which the wires can be seen should be faced to the “=” sign and if you feel hard to insert, please stop,

and don’t force it, for that may result in bent pins inside the port or overheating of the expansion board.

Need help?

Do you have a question about the Caterham SEVEN 620R and is the answer not in the manual?

Summary

Install dot lights into the front headlight and blinker assemblies, ensuring correct placement.

Lay cables through the vehicle body and connect them to the main expansion board.

Install dot lights for the rear of the Caterham, including tail and license plate illumination.

Connect all remaining cables, install the battery pack, and complete the kit assembly.

General