CAVOE AXO - OPERATION MANUAL; UNFOLDING THE STROLLER; ATTACHING AND REMOVING WHEELS; ARTICULATED FRONT WHEEL SYSTEM

OPERATION MANUAL
UNFOLDING THE STROLLER
In order to unfold the stroller, release the automac lock (g. 1),
and pull the stroller guiderail upward unl fully unfolded (g. 2, 3).
NOTE! Before starng to use the pram, make sure that it has been
correctly unfolded.
ATTACHING AND REMOVING WHEELS
To aach the front wheels, push their hubs into the mounts
on the ends of the front tubes (g. 4). To remove the wheels, press
the buon on the side of the wheel holder and pull the hub out of
the holder (g. 5). To aach the rear wheels, push their hubs into
the mounts on the rear suspension (g. 6). To remove the wheels
press the metal buon on the boom of the wheel mounts and
slide the hubs out (g. 7).
ATTENTION! Make sure the wheels are correctly aached prior
to use.
ARTICULATED FRONT WHEEL SYSTEM
The stroller has arculated front wheels, which may also be locked
in a forward facing posion. To allow the wheels to rotate, move
the lever on the front of the wheel down (g. 8).
To lock the wheels for straight driving, move the lever upwards.
PARKING BRAKE
The pram is equipped with a rear parking brake. To engage
the brake, press its lever down (Fig. 9). In order to disengage it,
li the lever.
NOTE! Before starng to push the pram, make sure that the brake
has been disengaged.
NOTE! Always engage the safety brake, when you leave the pram
on an inclined surface.
NOTE! The brake is not designed for slowing down. It should
be engaged aer the pram has been stopped completely.
NOTE! The pram is not designed for running.
ASSEMBLY AND REMOVING THE SEAT
In order to assembly the seat, unsck the seat adapters from
the handle on the stroller frame. The seat can be assembly both
facing and back to the direcon of travel (g. 10).
NOTE! Before using, make sure that the seat is properly assembled.
NOTE! Never move the stroller by holding the seat. In order
to remove the seat, push the buons located on both sides
of its adapters and pull the seat up (Fig. 10).
ASSEMBLY AND REMOVING THE CANOPY
In order to assembly the canopy, insert its hooks on the handles
on the stroller frame (g. 11). Set the canopy in the desired
posion (g. 12). The canopy is equipped with addional part with
venlaon grid. In order to reveal it, unzip the top of the canopy.
ASSEMBLY AND REMOVING THE BAR
In order to assembly the bar, insert its hooks on the handles on the
seat side tubes. In order to remove it, push the buons located
in the lower part of the handles and slide the clips out (g. 13).
Remove the handrail before folding the pram.
NOTE! Never move the stroller by holding the bar.
NOTE! Using the bar does not exempt from the obligaon to use
the seat belts.
FOOT REST ADJUSTMENT
In order to lower the foot rest, press the round buons on its sides
(g. 14). In order to raise the foot rest, just push it upwards.
NOTE! The foot rest is to support the legs of a child. If a child
is in a sing posion, the foot rest must be lowered.
BACKREST ADJUSTMENT
The stroller has 3-step adjustment of the backrest. In order
to lower the backrest, pull the lever on the rear of the backrest
and set the desired posion (g. 15). In order to raise the backrest,
just push it upward. It locks automacally in that posion.
SAFETY HARNESS
The pram has a ve point safety harness appropriate for children
from birth. The shoulder straps should be adjusted to the child’s
age. There are two pairs of slots in the backrest for the shoulder
straps. The lower slots should be used for children less than six
months old. The upper slots should be used for children more than
six months old. To put the ve point safety harness on, connect
the shoulder straps with the hip straps and then slot them into
the central buckle aached to the groin strap. (g. 16). Adjust all
the straps and belts so that
8. The repair method shall be determined by the guarantor,
9. The product subject to a complaint should be provided
clean,
10. The warranty is valid within the European Union,
11. The consumer goods warranty does not exclude or
suspend the purchaser’s rights stemming from goods non-
compliance with the agreement.
they are snug with the child’s body, but at the same me are not
uncomfortable (g. 17).
To open the harness press the buon on the central buckle
and disconnect all straps (g. 18).
ATTENTION! If the pram is used to carry a child less than 6 months
old, the backrest has to be in a “lying down” posion.
GUIDE HEIGHT ADJUSTMENT
The pram has a telescopic height-adjustable guide. To make
the adjustment, press the buon in the centre and adjust the
height.
FOLDING THE PRAM
To fold the pram, rotate the front wheels as shown in the gure.
Then fold the seat by pushing the foothold towards the backrest
(g. 19). Slide the small buon on the pram’s guide to the side,
hold it and at the same me press the big buon (g. 20). Push
the handle unl the pram is completely folded (g. 21).
ATTACHING AND REMOVING THE CARRYCOT
In order to aach the carrycot press it into the pram frame so that
the adapters on both sides of the carrycot lock onto the catches on
the pram frame (g. 22, 23). They will lock in place automacally.
ATTENTION! Make sure the carrycot is aached correctly prior
to use. To remove the carrycot press the buons on the adapters
at the sides of the carrycot and pull the carrycot upwards (g. 24).
en
9