EasyManua.ls Logo

CAVOE IDEO - Page 9

Default Icon
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATION MANUAL
UNFOLDING THE PRAM
To unfold the pram straighten up the upper part of the guide
(pic. 1). Next press the securing buon and twist the folding
mechanism towards direcon pointed with arrow (pic. 2)
and move vigorously forward and li it. Finally li pram’s backrest
(pic. 3 , 4).
ATTACHING AND REMOVING WHEELS
To aach the front wheels, push their hubs into the mounts
on the ends of the front tubes (pic. 5). To remove the wheels press
the buon on the back of the wheel mounts and slide the hubs
out (pic. 6).
To aach the rear wheels, push their hubs into the mounts on the
rear suspension. (pic. 7). To remove the wheels press the metal
buon on the boom of the wheel mounts and slide the hubs out
(pic. 8).
ATTENTION! Make sure the wheels are correctly aached prior
to use.
PARKING BRAKE
The pram is equipped with a rear parking brake. To engage the
brake, press its lever down (pic. 9). In order to disengage it, li the
lever.
NOTE! Before starng to push the pram, make sure that the brake
has been disengaged.
NOTE! Always engage the safety brake, when you leave the pram
on an inclined surface.
NOTE! The brake is not designed for slowing down. It should
be engaged aer the pram has been stopped completely.
NOTE! The pram is not designed for running.
ASSEMBLY AND REMOVING THE BAR
In order to assembly the bar, insert its hooks on the handles on the
seat side tubes (pic. 10). In order to remove it, push the buons
located in the lower part of the handles and slide the clips out
(pic. 11). There is no need to remove the bar before folding the
stroller.
NOTE! Never move the stroller by holding the bar.
NOTE! Using the bar does not exempt from the obligaon to use
the seat belts.
FOOTREST ADJUSTMENT
To unfold the footrest pull the leverage at the front (pic. 12). To li
it just push it up (pic. 13).
CAUTION! The footrest is designed only to support child’s legs.
If a child is in seang posion, the footrest must be lowered.
BACKREST ADJUSTMENT
The stroller has 3-step adjustment of the backrest. In order
to lower the backrest, pull the lever on the rear of the backrest and
set the desired posion (pic. 14). In order to raise the backrest, just
push it upward. It locks automacally in that posion.
SAFETY HARNESS
The pram has a ve point safety harness appropriate for children
from birth.
The shoulder straps should be adjusted to the child’s age. There
are two pairs of slots in the backrest for the shoulder straps.
The lower slots should be used for children less than six months
old. The upper slots should be used for children more than six
months old.
To put the ve point safety harness on, connect the shoulder straps
with the hip straps and then slot them into the central buckle
aached to the groin strap. Adjust all the straps and belts so that
they are snug with the child’s body but at the same me are not
uncomfortable (pic. 15, 16). To open the harness press the buon
on the central buckle and disconnect all straps (pic. 17).
ATTENTION! If the pram is used to carry a child less than 6 months
old, the backrest has to be in a “lying down” posion.
SWIVEL SEAT INSTALLATION AND REMOVAL
To install the swivel seat, plug its pin into round holder on the pram
(pic. 18).
CAUTION! Make sure that the seang is properly installed before
use.
To remove the seat pull the plasc leverage under the seat (pic.19).
FUNCTION OF SWIVEL SEAT
There is a swivel seat funcon. To rotate it set the backrest
in seang posion, li the footrest to vercal posion and pull
the footrest adjustment leverage (pic. 20). In this seng you can
rotate it (pic. 21A, 21B). The seat will lock automacally facing or
inversely the driving direcon, and you shall hear characterisc
locking sound.
10. The warranty is valid within the European Union.
11. The consumer goods warranty does not exclude or suspend
the purchasers rights stemming from goods non-compliance
with the agreement.
PRAM FOLDING
Set the seat inversely the driving direcon. Tilt the backrest far
forward (pic. 22). Next press safety buon and twist the folding
mechanism towards poinng arrow direcon and push the guide
down and forward (pic. 23). Push the frame unl it is locked. Once
again press the safety buon and twist the folding mechanism to
enrely fold the guide (pic. 24, 25, 26).
You can also fold the pram with seat facing driving direcon,
following the same steps, but it’s size aer folding will be much
bigger and irregular.
en
9

Related product manuals