8. With all of the wires connected, you may now connect your output connector. If you are using a
8pin miniDIN(NESRGB/Framemeister pinout), NeoGeo AES, or any other pin configuration that
expects no components in the cable, use the pad labeled CS75 for 75ohm impedance CSync.
This signal should be compatible with all 75ohm CSync capable devices. If you are using a
Genesis/MegaDrive 9pin miniDIN or Genesis/MegaDrive 8pin DIN you will also need to remove
and bridge the pads for resistors R16, R17, and R18 on the RGB board. As well as capacitors
C8, C9, and C10 on the same board. You may then use the CS-TTL pad for a TTL level CSync.
This CSync does require a 470ohm resistor and 220uf capacitor on the sync line to prevent
damage to your output device. This is installed by default on any properly made
To Next Page
Loading...