18
GB
The EC declaration of conformity for this appliance is available in the Products section of our
website www.ceado.com.
INSTALLATION
Comply with the Safety recommendations indicated above and hereafter when installing the
appliance.
For the installation of the appliance, qualified personnel must be present who are able to check the
fineness of the grind.
1. Make sure that the mains voltage is as indicated on the rating label of the appliance and that
the electrical system is grounded and equipped with a switch.
2. Install the appliance in a DRY, PROTECTED place, far from water sprays and jets, heat
sources, open flames and inflammable substances.
Place the appliance on a flat, horizontal, stable surface where it cannot tip over.
3. Put the tray in its housing to keep the work area as clean as possible. Place the bellows in its
housing.
Before connecting the plug to the power socket, make sure that the ON-OFF switch
(12 Fig. 2) is in position “O” (OFF).
4. Plug the power cable into a socket protected by a suitably rated circuit breaker (MCB) or fuses.
Do not use an adaptor plug.
5. Stretch the power cable out to full length. Do not let it pass over sharp edges or hot surfaces.
Do not let oil spill on it. Do not let the power cable hang loose from the counter on which the
appliance stands.
PREPARATION AND USE
SWITCHING ON
Turn the ON-OFF switch to position “I” (12 Fig. 2).
Prepare the desired quantity of coffee beans to be grind.
Position the filter-holder on the fork (10 Fig. 1) (with or without the supplied funnel 14 Fig. 2). If
you want to pour the coffee into the container provided, insert it with its base in the fork.
Start the motor with the ON-OFF button (7 Fig. 1).
Always start the motor of the coffee grinder before putting coffee beans into the bellows
(running empty).
To reduce static electricity (present especially in some types of coffee) apply 2-3 splashes of
5
1
4
3
2
To Next Page
Loading...
