cecotec BAKE&FRY 3000 TOUCH - Page 47

BAKE&FRY 3000 TOUCH/WHITE
47
ENGLISH
White smoke comes out of
the appliance.
The device is being used for
the rst time.
It is normal for it to happen
during the rst use. It is
recommended to set the oven
at maximum temperature and
let it run on empty for 18 to 20
minutes.
You are preparing greasy
ingredients.
This is normal when cooking
greasy foods. This will not
affect the cooking process.
The baking tray, crumb tray
or heating elements still have
grease or oil residues from
previous use.
Ensure that each component
is thoroughly cleaned after
each use.
Black smoke comes out of the
device
The food is burning. Immediately turn off the oven
and remove the food.
Food cooked in the oven is
uncooked.
There is too much food inside
the oven.
Do not put too much food in
the oven at once.
The temperature is too low
or you have programmed too
little time.
Select a higher temperature
or set a longer time.
You have selected the wrong
function.
Make sure you select the
correct function.
The food has not been cooked
uniformly.
Food is stacked or in close
proximity to each other
during cooking.
Be sure to distribute the
ingredients evenly.
The position of the oven tray,
air fryer basket or oven rack
has not been adjusted.
Insert the desired tray in the
correct position. Be careful,
these components can be
very hot.
The food is not crispy after
cooking in the air fryer.
Foods with high water
content.
Spraying or brushing a
small amount of oil on food
can help to achieve crispier
results.
The display shows Error code
"E1".
Short-circuit in the
temperature controller.
Unplug the cord from the
power supply. Contact the
ofcial Technical Support
Service of Cecotec.