cecotec BONGO Z+ ON ROAD - 2. Parts and Components

6160
BONGO Z+ ON ROAD
BONGO Z+ OFF ROAD
BONGO Z+ ON ROAD
BONGO Z+ OFF ROAD
ENGLISH ENGLISH
ORIGINAL MANUAL TRANSLATION
11. Front reector
12. Foldable bar
13. Front axle
14. Front-suspension top mount
15. Front fender
16. Front wheel
17. Front suspension
18. Front disc brake
19. Headlight
20. Side reector
21. Side light cover
22. Platform
23. Pedals
24. Charger input
25. Rear light cover
26. Rear suspension
27. Lower rear-deck cover
28. Rear disc brake
29. Rear wheel
30. Rear mudguard
31. Number-plate holder
32. Rear light
33. Controller cover
34. Rear cover
35. Kickstand
Fig. 23
1. On/O button: short press to turn the electric scooter on and long press to turn it o. A
short press on the electric scooter will turn on the lights or turn them o if they are on.
2. SET: short press on the touch icon to change the speed units.
3. MODE: short press on the touch icon to switch between the three modes or press and
hold to switch the cruise-control setting mode on or o.
4. LIGHT: press this touch icon to switch between the dierent light modes.
Fig. 24
1. Real-time current monitoring
2. Temperature
3. Speed
4. Light mode
5. Start mode
6. Riding mode
WARNING! Regularly check the condition of components or parts subject to wear or fatigue,
such as the chassis, fork, tyres, brakes, etc. This will allow you to detect cracks or damage in
high-stress areas that may indicate the component’s service life has been exceeded and needs
to be replaced. Regular maintenance of the electric scooter and its components will extend its
service life. Periodically check the tightness of bolted parts, especially the wheel axles and the
folding, steering, and braking systems.
- Contact your vendor to be referred to an appropriate training organisation.
- Avoid high trac or overcrowded areas and anticipate your path and speed by respecting
the road’s trac code, the pavement, and pedestrians
- Indicate your presence when approaching a pedestrian or cyclist and when you are not
seen and/or heard. Remember to cross at the pedestrian crossing when walking and
always take care of yourself and others. Remove any sharp edges that may have been
caused using the vehicle.
- Do not modify the use of the vehicle. This vehicle is not designed for stunt use.
Using the scooter properly
- Do not wear loose clothing, scarves, necklaces, or other items with long chains or strings.
- Do not drive with objects in your pockets, hands, or mouth.
- Do not rest your feet on the ground while driving.
- Do not get o the vehicle while in movement.
- Do not attempt to do jumps or stunts while on top of the electric scooter.
- Do not read, write, drink, or eat while driving.
- Avoid riding the electric scooter on unstable or dangerous surfaces such as roads with
sinkholes or elevation changes.
- Do not drive the vehicle in an awkward position and/or use your feet for braking.
2. PARTS AND COMPONENTS
Fig. 22
1. Handlebar grips
2. Handlebar
3. Brakes and bell
4. Accelerator
5. On/O button
6. Handlebar base
7. Retaining strap
8. Control panel
9. Post
10. Folding-system screw