CONGA 2299 INERTIAL X-TREME
54
ENGLISH
Mesh primary lter and sponge lter. Fig. 8.
The ltering system is featured with a primary mesh lter and a sponge lter, located next to
the high-eciency lter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall o. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can reach
the robot vacuum cleaner’s motor and damage it.
Cleaning the fall-detection sensors
Use a clean, dry and soft cloth to wipe o any dust from the fall-detection sensors located on
the robot vacuum cleaner’s lower part.
Warning
Do not apply cleaning products directly on the sensors.
Cleaning the main brush. Fig. 9.
The main brush rotates at high speed and helps pushing the dirt into the suction mouth. This
brush is in contact with the oor, and therefore with dirt, so it can wear out overtime, negatively
aecting cleaning eciency. For this reason, it is suggested to replace the main brush after a
maximum of 320 hours or less.
1. Slightly press the main brush frame’s tabs to open the main brush compartment and
remove it.
2. Remove hair, lint, and other dirt trapped in the brush and around the shafts with the help
of the self-cleaning brush.
3. Clear and clean the robot vacuum cleaner’s suction channel.
4. Reinstall the main brush and its frame.
Recommendation
It is recommended to clean the main brush once a week with the help of the self-cleaning
brush.
Side brushes. Fig. 10.
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
mouth and to thoroughly clean edges and corners. These brushes can wear out overtime,
negatively aecting cleaning eciency. For this reason, it is suggested to replace each side
brush after a maximum of 220 hours or less.
To Next Page
Loading...
