cecotec CONGA 2299 INERTIAL X-TREME - Fan and main brush errors; Common operational problems

CONGA 2299 INERTIAL X-TREME
56
ENGLISH
3 Fan error Clean the dust or objects that may be blocking the air inlet
channel.
4 Main-brush fault Check if the main brush is blocked or tangled and clean it.
Other possible scenarios:
Problem Solution
The robot vacuum cleaner
does not activate.
Make sure the battery is fully charged.
If the problem persists, reset the robot vacuum cleaner by pressing
the RESET button.
The robot vacuum cleaner
suddenly stops working.
Check if the robot vacuum cleaner is trapped or stuck with any
obstacle.
Check the battery level.
If the problem persists, turn the robot o and then on again. If the
issue persists, press the RESET button.
The programming function
does not work.
Check if the robot vacuum cleaner battery is too low to turn on.
Suction power level is very
low.
Check if there are obstructions blocking the air inlet.
Empty the tank.
Clean the lters with a vacuum cleaner or a self-cleaning brush.
Check if the lters are wet.
Dry the lters in a natural way before using them. Make sure they
are completely dry. If there are any moisture remains, they could
reach the motor and damage the robot vacuum cleaner.
The robot vacuum cleaner
does not charge.
Check if the charging base indicators are on. Otherwise, contact the
ocial Technical Support Service of Cecotec.
Clean the charging terminals with a clean, dry cloth.
Check if the robot vacuum cleaner beeps when it gets to the
charging base. Contact the ocial Technical Support Service of
Cecotec.
The robot vacuum cleaner
does not return to the
charging base.
Remove the objects 1 metre on the left and right, and 2 metres in
front of the charging base.
The robot vacuum cleaner will return to the charging base faster
when it is near it. When it is far, it will take more time to identify it.
Clean the charging terminals.