CRUSHER 140020
- Never immerse the motor unit in water or any other liquid,
nor rinse it under running water. Only use a damp cloth to
clean the motor unit.
- Do not attempt to mince bones, nuts, or other hard objects.
- Never reach inside the cutter housing. Always use the
food pusher.
- Introduce boneless, lean beef, cut into pieces of approximately
20 mm x 20 mm x 60 mm. The food pushers must exert a
force of 5 N against the meat. Do not operate the appliance
for more than 5 consecutive minutes. Allow the device to
cool down for 10 minutes before using it again.
- If the appliance is locked, turn the knob to reversal direction
( ). The meat trapped in the cutter housing will be released,
allowing the appliance to return to its normal state.
To Next Page
Loading...