cecotec FORCECLIMA 7050 - Remote Control Functions; Protection Functions and Drainage

ENGLISH
25
FORCECLIMA 7050
Press the key to turn the device on and o. During operation, press it to turn it o, while it is
turned o, press it to turn it on.
NOTE: you cannot activate the sleep mode in the dehumidifying or Fan mode. Use only the
remote control in order to set it in standby mode.
REMOTE CONTROL
Remote control functions:
• 1. Fan: press
to select high, low wind speed.
• 2. Up: press to increase temperature and timing set value
• 3. Mode: press to switch between cooling, dehumidifying, fan mode.
• 4. Sleep mode: Press to turn on the sleep mode.
• 5. Down: press to reduce temperature and timing set value.
• 6. Timer: press to set timing.
• 7. Power: Press to turn on or turn o the machine.
PROTECTION FUNCTIONS
Anti-frost function:
During cooling mode, if the temperature of the EVA pipe sensor is too
low, the machine will automatically activate protection functions. If
the temperature of the EVA pipe sensor rises to a certain temperature, it can automatically
resume normal operation.
Overflow protection function:
When water in the device’s water tray exceeds the warning level, the machine will automatically
emit an alarm, and the W.F indicator will flash. At this point, you need to move the drainage
pipe connecting the machine or the water outlet to sewer or other drainage area to empty the
water (see Drainage Instructions at the end of this chapter). After the water is emptied, the
machine will switch to standby.
Compressor protection function:
To increase the service life of the compressor, it has a 3-minute delay booting protection
function after the compressor is turned o.
DRAINAGE INSTRUCTIONS
Manual drainage:
• When the machine stops after the water is full, turn o the machine power and unplug it
from the power supply.
WARNING: Please move the machine carefully, so as not to spill the water in the water pan at
the bottom of the body.
• Place the water container below the side water outlet behind the body.
• Unscrew the drainage cover and unplug the water plug, the water will automatically flow
into the water container.
5
6
2 3
7
1
4
05244_FORCECLIMA 7000_Manual_LI_MV.indd 25 19/12/18 12:51