cecotec FREEGO WASH TWICE SPRAY - Operation; Charge Indicator Light; Using the Electric Mop; Appliance Usage and Storage

FREEGO WASH TWICE SPRAYFREEGO WASH TWICE SPRAY
4544
ENGLISH ENGLISH
7. TECHNICAL SPECIFICATIONS
Product reference: 04552
Product: FreeGo Wash Twice
Rated input power: 60 W
Adapter: 100-240 V, 50-60 Hz
Power rating of the oor-brush motor: 25 W
Spray-pump power: 5 W
Battery capacity: 2000 mAh
Charging time: approximately 4-5 hours.
Technical specications may change without prior notication to improve product quality.
Made in China | Designed in Spain
7. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or batteries must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should dispose
of the cells/batteries/accumulators and take them to a collection point
designated by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old machines and/or their batteries.
Compliance with the above guidelines will help protecting the environment.
8. TECHNICAL SUPPORT AND WARRANTY
Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the
time of delivery of the product under the terms, conditions, and deadlines established by the
applicable regulations.
It is recommended that repairs be carried out by qualied personnel.
If at any moment you detect any problem with your product or have any doubt, do not hesitate
to contact the ocial Cecotec Technical Support Service at +34 963 210 728.
9. COPYRIGHT
The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES,
S.L. All rights reserved. The contents of this publication may not, in whole or in part, be
reproduced, stored in a retrieval system, transmitted, or distributed by any means (electronic,
mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC
INNOVACIONES, S.L.
Notes
- After using the appliance, the rotary brush will be wet. Leave it in a well ventilated area
until it dries to ensure it does not aect operation.
- If the rotary brush is wet, the appliance must not be used in environments below 0 °C to
prevent it from freezing and damage.
Storage
- After using the appliance, place it on the support to prevent the wet bristles from touching
and, in turn, damaging the oor.
- It is advisable to clean the rotary brush before storing the appliance, and then store it in
a cool, ventilated place to prevent the bristles from deforming and emitting unpleasant
odours. This will prevent its service life from being aected.
- If the appliance is not going to be used for a long period of time, it is recommended to store
it as described above, in a cool and dry place. Do not store it under direct sunlight or in
damp places.
6. TROUBLESHOOTING
Problem Possible causes Possible solution
The rotary brush does not rotate.
The rotary brush is pressed down by a
heavy object or has too much hair on it.
Low battery. Charge the appliance.
Remove heavy
objects and/or hair.
No water comes out of the pump.
Blocked by foreign objects.
The clean-water
tank has run out of
water.
Fill up the clean-water
tank.
Clean the dirt from
the nozzle and clean
the waste-water
tank.
Indicator light status
during charge.
(charging: red light).
Green light. Battery is fully
charged.
Check that the battery is
fully charged.
Sudden
switch-o
The charging
adapter is not
properly connected.
Correctly plug in the
adapter.
Insucient operating time after charging.
Battery time
Insucient charge
time.
The battery is a
consumable product. You
can get a new battery from
Cecotec.