32
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Drip tray
2. Coffee spout
3. Steam tube (cappuccinatore)
4. Water tank
5. Left-side door
6. Power cord
7. Control panel
8. Funnel lid
9. Ground coffee funnel
10. Coffee bean tank
11. Right-side door
12. Brewing unit
13. Residues tank
14. Coffee grinder knob
15. Steam tube knob
16. Milk tank
17. ON/OFF button
18. Switch
Control panel
Fig. 2
2. BEFORE USE
Take the product out of the box and remove all packaging materials.
Make sure all parts and components are included and in good conditions. If any visible signs of
damage are observed, contact the Technical Support Service immediately.
Remove the water tank from the coffee machine and ll it with fresh water.
Fill the coffee bean tank with coffee beans.
Insert the power plug into the wall socket.
Press the power switch one or twice if the display is blank.
Allow the machine to preheat.
Place a cup under the drink spout.
The appliance will enter standby mode and will be ready to brew coffee.
Note: It is suggested to use bottled water in order to achieve optimal taste of coffee.
Fig. 3
To Next Page
Loading...
