Quick Set-up Guide
1
PowerSeeker 114EQ & 127EQ
Your PowerSeeker 114EQ or 127EQ includes: optical tube w/
tube rings attached; tripod with center leg brace; equatorial
mount; 2 eyepieces; a 3x barlow lens, finderscope; 6 lb.
counterweight (#21049 has 6 lb. & 2 lb. counterweights);
counterweight bar; two slow motion cables; eyepiece
accessory tray; The Sky
®
Level 1 software, owner’s manual.
Item# 21045
Questions or Problems with Set-up?
CONTACT:
Celestron Technical Support: 310.803.5955
Item# 21049
2
3
All three legs should be the same length to provide a level
platform for the telescope.
4
7
Locate the equatorial mount and place the base of the mount
through the hole in the center of the tripod mounting
platform.
5
Properly assembled, the accessory tray should appear as
pictured above.
6
From underneath the tripod mounting platform, thread the
attached mounting bolt into the hole on the bottom of the
equatorial mount.
8
Thread the latitude adjustment screw into the equatorial
mount until it is touching the inside of the mount.
9
Place the accessory tray on top of the tripod's center leg
brace. Thread the tray into the threaded hole in the center of
the leg brace.
Extend the center portion of each of the three tripod legs
down 6-12". Use the three tightening screws located at the
bottom of each leg to secure the extended legs in place.
To set up the tripod, spread the legs outward until they are
fully extended and push down center leg brace.
PowerSeeker 114EQ shown
To Next Page
Need help?
General
