Page 3For technical questions, please call 1-800-444-3353.ITEM 60332
Operation
NOTE: Do not use Scale for
commerce or trade.
1. Place the Scale on a at, hard surface.
2. Remove the cover.
3. Press the ON/OFF button once.
The Scale will display everything
while starting up -
see Figure A: Startup Screen.
When the Scale shows
zero 0.0g it is ready for use.
Figure B: Scale ready
Note: If battery is low, Lo (Low Battery)
will be shown. See Figure C.
Figure C: Low Battery
To Replace Batteries:
a. Open battery cover,
remove old batteries and
dispose of them properly.
b. Install 2 new “AAA“ batteries
according to proper polarity and
close cover. Do not install batteries
of different types, charge levels,
or capacities together.
4. Press MODE to cycle through
weight units. Current weight unit is
displayed on the right of the display.
5. TARE mode:
To set the Scale to ignore the weight of
a container and weigh only contents,
place empty container on Scale
and press TARE.
tare will be displayed and the Scale will
ignore the container’s weight.
Remove container and press TARE
again to cancel tare mode.
6. PCS mode:
This mode is used to count small
objects. To get an accurate count,
it is essential that the objects all weigh
the same. To set up PCS mode:
a. Place 25, 50, 75, or 100 quantity
of the objects on the scale.
b. Press and hold PCS for 3 seconds.
c. Press MODE to match the quantity
of objects on the scale. Available
numbers are 25, 50, 75, and 100.
d. Press PCS to conrm the quantity.
pcs will be displayed.
7. Gently place item to be weighed on
the center of the platform. The weight
(or quantity of objects for pcs mode)
will appear on the display.
Note: If too much weight is placed
on the platform, the display will read
O,Ld (Overload) as shown below.
Figure D: Overload
8. To turn off Scale,
press the ON/OFF button.
Note: The Scale will automatically turn
off 60 seconds after item is weighed.
To Next Page
Loading...
Need help?
General
