3-Series
Micro Door Sensor
QUICK START GUIDE
3320
Device Overview
Getting Started
Powering Up and Pairing
1. Pull and remove the “Pull to Pair” tab from the
Micro Door Sensor. The device will power up and
begin searching for a ZigBee network to join.
2. Initiate pairing on the home gateway/hub.
3. The Micro Door Sensor should start the joining
process automatically. While the sensor is
searching for a network, the status LED will
periodically blink blue.
Once the Micro Door Sensor has successfully
joined the network, the status LED will turn solid
blue for 2 seconds, then turn off.
4. Finish pairing setup from your home gateway/hub.
LED Light Patterns
Pattern Description
Blue | Blinking Establishing Connect / Joining
Green | Short Joining Successful
Red | Blinking then
White | Solid
Power Outage /
Emergency Lighting
Red | 3 Blink Series Low Battery
Magnet
Reset Hole
Battery Tray
CR-2450 Battery
SensorMagnet
Mounting Clips
To Next Page
Need help?
General
