How to troubleshoot loss of power in Century 400 Floor Machine?
If your Century 400 Floor Machine loses power, first ensure it is properly connected to a grounded, three-prong outlet. If it is plugged in, check your building's circuit breaker or fuse box to rule out a dead electrical circuit. Lastly, a faulty power cord could be the culprit, in which case it should be replaced.
What to do if Century 400 Floor Machine loses vacuum?
If the Century 400 Floor Machine experiences loss of vacuum, several issues could be the cause. Here's what to check: * Ensure the vacuum dome is centered and sealed over the tank. * Inspect for cracks in the dome or a poor joint; replace or repair with acrylic plastic cement if needed. * Clean the vacuum screen to remove any lint or dirt. * Tighten loose cuffs on the vacuum hose by turning them counterclockwise. * If the recovery tank is full or the float ball is stuck, turn off the power and drain the tank. Other potential causes include leaking vacuum motor seals, a clogged floor tool vacuum chamber, or a damaged vacuum hose, all of which may require replacement or cleaning.
Why am I getting electrical shocks from Century 400 Floor Machine?
If you experience an electrical shock from the Century 400 Floor Machine, it could be due to a receptacle that is not grounded. In this case, contact an electrician to check the building's wiring. It may also be due to an internal wiring problem, which would require a trained service technician to check the machine's wiring.
General| Model | NWCU2220N |
|---|---|
| Category | Floor Machine |
| Power | 1.5 HP |
| Weight | 105 lbs |
| Speed | 175 RPM |
| Motor Power | 1.5 HP |
| Speed Settings | Single Speed |
| Warranty | 1 year |
| Power Source | Electric |
Key precautions for safe operation, handling, and maintenance of the machine.
Explanation of hazard warning symbols and their severity for safe operation.
Illustrations and locations of essential safety labels on the machine.
Proper electrical grounding procedures to prevent shock hazards.
Identification and function of all controls and indicators on the machine.
Instructions on operating the machine, including chemical usage and safety.
Guide to diagnosing and resolving common problems encountered with the machine.
Covers warranty terms, durations for different components, and coverage limitations.
To Next Page
