Cete Automotive Active Sound Gateway BLE User Manual

Cete Automotive GmbH - Elmshorner Straße 33 - 25358 Horst - info@Active-Sound.eu
Installation
Active Sound
Active Sound Gateway BLE

Cete Automotive Active Sound Gateway BLE Specifications

General

Category	Car Receiver
Connectivity	Bluetooth
Operating Voltage	12V
Compatibility	Universal
Bluetooth Version	BLE (Bluetooth Low Energy)

Summary

Safety Instructions

Technical Specifications

Installation ASG (A4 / A5)

Step 1) Place of Installation (A4/A5)

Find the installation location in the rear trunk of your car and open it.

Step 2) Place of Installation (A4/A5)

On the left side of the rear trunk, find and open a cover.

Step 3) Control Unit (A4/A5)

Locate the control unit, which could be behind the amplifier.

Step 4) Active Sound Gateway (A4/A5)

Connect the Active Sound Gateway between the control unit and the harness.

Installation ASG (A6 / A6 Avant / A7)

Step 1) Place of Installation (A6/A7)

Locate the installation point in the rear trunk of the vehicle.

Step 2) Place of Installation (A6/A7)

Step 1) Place of Installation (A6 Avant)

Step 2) Place of Installation (A6 Avant)

Step 3) Control Unit (A6/A6 Avant/A7)

Step 4) Active Sound Gateway (A6/A6 Avant/A7)

Installation ASG (SQ5 / Porsche Macan)

Step 1) Place of Installation (SQ5/Macan)

Step 2) Remove Bottom Covers (SQ5/Macan)

Step 3) Loosen Holder Screws (SQ5/Macan)

Step 4) Remove Left Cover (SQ5/Macan)

Step 5) Control Unit (SQ5/Macan)

Step 6) Preparation (SQ5/Macan)

Step 7) Active Sound Gateway (SQ5/Macan)