/,*+7,1*,167580(1766:,7&+(6
2YHUKDXO,QIR+RUQ
7URXEOHVKRRWLQJGDVKERDUG
5HSODFLQJEXOEV )XHO6HQVRU
KHDGOLJKW:DWHU7HPSHUDWXUH7UDQVGXFHU
,JQLWLRQ6ZLWFK
+DQGOHEDU6ZLWFK
%UDNH/LJKW6ZLWFK
Overhaul Information
Warning
Headlight bulb will be very hot when it is turned on. Do not touch it after it is just turned off. Operation
should be done when the bulb is cooled down.
Inspection of water temperature alarm may use fire source and liquid of high temperature. Do not put
flammable matters nearby and take care not to get burnt.
The temperature of headlight is quite high when turned on. Replacing with bare hand or stained glove will
cause oil stains on the glass face which may form hot spot and cause deformation of glass face and
damage to bulb.
Pay attention to the following when replacing the bulb.
—-Do not replace the bulb when it is turned on. Keep ignition switch in the OFF position, and replace
after the bulb is cooled down.
—Replace the bulb with hands in clean gloves to avoid oil stains on the glass surface.
—Clean the glass with a clean rag dipped in alcohol or isoamyl acetate in case of any oil stains on the
glass surface.
If the Inspection has to be done with battery, check if the battery is normal.
Inspection of switch continuity can be done without removing the switches from the vehicle.
After the inspecting and overhauling of each part, cables and wires should be routed properly (?chapter 1)
Refer to Chapter 2 for removal and installation of taillight and rear turning lights
2YHUKDXO6WDQGDUG
Item Standard
Main 20AFuse
Sub-fuse
$ 15A$3
HeadlightHiLo
12V-55/55W
Brake lightTail light
12V-21/5W
Turning light
12V-10W$4
Dashboard Indicator 12V-1.7W
Light,bulb
Indicators 12V-3.4W
To Next Page