CF MOTO CF600UU - Page 136

MAINTENANCE
136
Change the Engine Oil
1. Place vehicle on level ground with the transmission in park.
2. Start the engine and warm for ( 2~3 ) minutes, then stop the
engine.
3. Place a pan under the engine oil drain hole
1
to collect the
used engine oil.
4. Remove the dipstick and wipe it clean.
5. Remove the magnetic drain bolt and washer
2
to drain out the oil.
6. Conrm the engine oil is drained completely.
7. Remove the three bolts
3
on the oil lter cover.
8. Remove the oil lter cover
4
.
9. Inspect the O-ring
6
in the cover, to ensure it is in good
condition. Replace with a new one if damaged.
10. Mount O-ring
6
into the oil lter cover, and apply a layer of
fresh engine oil for lubricating.
11. Install a new oil lter
5
.
12. Mount oil lter cover
4
, then install and tighten the cover
bolts to the specied torque.
Oil Filter Cover Bolt Torque: 7.3 ft-lb.( 10N·m )
13. Clean any debris or contaminants from the magnetic drain
bolt
2
. Replace the washer with new one if damaged.
14. Install the magnetic drain bolt and washer
2
.
Drain Bolt Torque: 18.5 ft-lb. ( 25 N·m )
1
2
3
4