MAINTENANCE
155
Brakes
Brake Fluid Level Inspection
Before riding, check that the brake fluid level is above the
low mark and replenish whenever necessary. The brake fluid
reservoir is located under the front access cover. Insufficient
brake uid may let air enter the brake system, possibly causing
the brakes to become ineective.
Observe these Precautions:
• When checking the uid level, make sure the vehicle is
on a level surface.
• Use only the designated quality brake fluid. Otherwise,
the rubber seals may deteriorate, causing leaks and poor
brake performance.
• Recommended brake uid: DOT 4.
• Rell with the same type of brake uid. Mixing uids may
result in a harmful chemical reaction and may lead to
poor brake performance.
• Be careful that water does not enter the master cylinder
reservoir. Water will signicantly lower the boiling point of
the uid and lead to poor brake performance.
• Brake fluid may deteriorate painted surfaces or plastic
parts. Always clean up spilled uid immediately.
• As the brake pads wear, it is normal for the brake fluid
≤120°
To Next Page