CF 600 - Instructions for Use of the CF 600 Pool Cleaner; Installation of the CF 600 Pool Cleaner; Immersion of the CF 600 Pool Cleaner

                
 


III. SpecificaCons and parameters








～

6
25
USEINSTRUCTIONS FOR USE
INSTALLATION
The power supply control box must be placed in a suitable position to ensure that the
cleaner can reach every corner of the swimming pool. At the same time, the position of
the power supply control box should not be less than 3.5 meters from the edges of the
swimming pool.
IMMERSION OF THE CLEANER
• When putting the cleaner into the swimming pool, the bottom of the cleaner shall face
the pool wall, hold the handle and put the cleaner into the water. And the cleaner
will slowly discharge the gas (the gas in the cleaner must be completely discharged,
otherwise it will aect the normal operation of the machine). Let the machine naturally
sinks to the bottom of the pool.
11. For the cleaning in different seasons, the filter screens with different density can be
changed. Please contact the agent to buy filter screen with different density.
12. Ensure that the PH value of the water of the swimming pool is 7.0-7.2.
13. It is forbidden to put water treatment chemicals into the machine, to use the machine for
chemical distribuCng. If the machine is damaged for this reason, the manufacturer is not
responsible for the warranty.
Ma[ers needing a[enCon:
1. When puXng the cleaner into the swimming pool, the bo[om of the cleaner shall face the
pool wall, hold the handle and put the cleaner into the water. And the cleaner will slowly
discharge the gas (the gas in the cleaner must be completely discharged, otherwise it will
affect the normal opera7on of the machine). Make the machine naturally sinks to the boJom
of the pool.
2. When taking out the cleaner from the pool, you only can hold the handle, do not pull the
cable.
3
11. For the cleaning in different seasons, the filter screens with different density can be
changed. Please contact the agent to buy filter screen with different density.
12. Ensure that the PH value of the water of the swimming pool is 7.0-7.2.
13. It is forbidden to put water treatment chemicals into the machine, to use the machine for
chemical distribuCng. If the machine is damaged for this reason, the manufacturer is not
responsible for the warranty.
Ma[ers needing a[enCon:
1. When puXng the cleaner into the swimming pool, the bo[om of the cleaner shall face the
pool wall, hold the handle and put the cleaner into the water. And the cleaner will slowly
discharge the gas (the gas in the cleaner must be completely discharged, otherwise it will
affect the normal opera7on of the machine). Make the machine naturally sinks to the boJom
of the pool.
2. When taking out the cleaner from the pool, you only can hold the handle, do not pull the
cable.
3