MAINTENANCE AND ADJUSTMENTS
6. Start the engine. (Refer to "Starting a cold engine" on page 69.)
7. After the engine starts, disconnect the negative lead of the jumper cable from the vehicle and
charged battery, and then disconnect the positive lead of the jumper cable from the charged battery
and the battery in the vehicle.
8. Reinstall the battery compartment cover.
9. Close the hood.
FUSE REPLACEMENT
The main fuse and the fuse box are located under the hood. (See page 108 for hood opening
and closing procedures.) If a fuse is blown, turn off the main switch and install a new fuse of the
specified amperage. If a fuse is blown, replace it as follows.
The key to the “OFF”
NOTICE: To prevent accidental short‐circuit turn off the main switch when checking or replacing
a fuse.
1. Remove the blown fuse, of the specified amperage.
position and turn off all the electrical circuit in question.
Always use a fuse of the specified amperage. Never use any material in place of the proper fuse.
Using an improper fuse can cause damage to the electrical system an may lead to a fire.
-146-
To Next Page
Loading...