Perform the following procedures before operation:
1. Fill the fuel tank with gasoline.
2. Put ATV on a level surface to check the oil level . Add recommended oil if necessary to maintain the oil
level between the minimum and maximum level marks of the dipsticks .
3. Drive slowly at first .
Select an open area that allows room to familiarize yourself with vehicle operation
and handling.
4. Vary throttle positions . Do not operate at sustained idle.
5. Perform regular checks on fluid levels , controls and areas outlined on the daily pre-ride inspection checklist.
-66-
Operation
6. Pull only light loads.
7. During the break-in period, change both the oil and oil filter at 20 hours or 750km .
To Next Page
Loading...