3. Proceed slowly, avoiding rocks and obstacles if possible.
4. After crossing, dry the brakes by applying light pressure to
the lever while driving slowly until braking
NOTE
Avoid operating the vehicle through deep or fast-flowing water. If you cannot avoid water that exceeds
the recommended maximum depth, go slowly, balance your weight carefully, avoid sudden movements,
and maintain a slow and steady forward motion. Do not make sudden turns or stops, and do not make
sudden throttle changes.
A
fter running the vehicle in water, it's critical to have it serviced as outlined in the maintenance chart.
The following areas need special attention: engine oil, trasmission oil, front and rear gear cases and all grease
fittings.
NOTE
If water has been ingested into the CVT housing, the drive belt will likely slip and poor performance will result.
To expel water and dry the CVT housing; Drain the CVT housing, place the vehicle in neutral, and raise the
engine rpm for several minutes to dry the CVT components. Release the throttle and shift into low gear, then test
-85-
Operation
the performance of the vehicle. Repeat as necessary until you are satisfied all the water has been expelled.
Contact your dealer if vehicle performance issues continue.
action is normal.
To Next Page
Loading...