-94-
Oil filter replacement
1. Use wrench to unscrew 3 pcs of bolts as right picture shows.
Then remove cover of oil filter and remove oil filter .
2. Install new oil filter on it.
Attention: Confirm if O-ring is good and then install it into
groove of crankcase correctly.
3. Install new oil filter ，and use wrench to tighten 3 pcs of bolts
on cover by specified torque.
NOTE
Tightening torque of bolt :10 N·m
4. Use new washer to assemble and tighten oil drain bolt as specified torque.
NOTE
Tightening torque of drain bolt: 30 N·m
5. Add the specified amount of recommended engine oil, and then insert
the engine oil dipstick and tighten it.
NOTE
In case of engine overhaul, oil should be added：2.6 L；
With oil filter cartridge replacement, oil should be added: 2.5L
:
:
:
6. Start the engine and warm it up for several minutes. While warming up,check for oil leakage. If oil
leakage is found, turn the engine off immediately and check for the cause.
7. Turn the engine off, and then check the oil level and correct it if necessary.
2
3
1
4
3
2
1
1
4
3
2
1
To Next Page
Loading...