46
Park
The park position locks the gearbox to help
prevent vehicle movement.
WARNING
Always use the PARK (P) position when the
vehicle is not in operation. The vehicle can
roll if the shift lever is not set to P (PARK).
Secondary Controls
1) Ignition Switch and Engine Stop Switch
The ignition switch and engine stop switch are
located on the bottom left of the dashboard.
WARNING
Do not leave the ignition key inserted when
the operator is away. An unauthorized
use of the vehicle by others may result in
serious injury or death. Always remember
to remove the ignition key when the
vehicle is not in use.
Ignition switch has 3 positions. Use a key to
control the ignition switch and then start the
engine.
When the key is in the position of “OFF”, it can
be removed from the ignition switch.
Ignition
switch
OFF
Engine is shut down. The
electrical except winch
motor’s and DC outlet’s is
disabled.
ON
The electrical system of
the vehicle is activated.
START
Turn ignition key to “
“
to start the engine. Ignition
key returns to ”On ” when
released.
Engine
stop
switch
Engine doesn’t work.
Engine is ready for work.
Note:
Do not keep the ignition switch in
“START “ for more than 10 seconds.
To Next Page
Loading...