45
Operation of appliances
?
Fan operation
Under fan operation, the “heater/ventilation” changeover
switch must firstly be activated before the heater is
triggered.
Switching off
When the heater is switched off the indicator lamp goes
out and the fuel no longer flows.
The fan operates by inertia for about four minutes as part
of the cooling process. The glow pin is switched on for
about forty seconds when the fan is operating by inertia
for cleaning purposes.
Special case:
The heater will stop operating without an inertia phase if
no more fuel flowed into it before it was switched on or if
it was in the «STOP» position.
Heating at altitude
Please consider the following points when heating at
altitude:
!=$5)3+/!&%!)*!>:::!,!5(*?$!'$5!0$?$0@!
- Unlimited heating possible.
!!=$5)3+/! 5)! 5+! 50)3)&.$! 5(*?$! AB::! ,! &%! )*! C:::! ,!
maximum:
- Short stay (crossing a pass or stopping for a break),
heating is possible in principle.
- Longer stays (e.g. camping in winter), heating is not
possible.
Maintenance instructions
!!D%$-5)$! )#$! #$5)$-! ;*-! )$+! ,3+&)$'! *+7$! 5! ,*+)#!!
outside the heating season.
!!=5?$! 5! )-350! -&+! 63)#! 1*&-! #$5)$-! ($;*-$! )#$! #$5)3+/!
season starts. If the burner emits heavy, persistent
smoke or unusual noises, or even a strong smell of fuel,
or if the electric/electronic parts overheat, switch the
heater off and take it out of service by removing the
fuse. Arrange for the heater to be inspected by specialist
Eberspächer trained personnel before switching it on
again.
!!E#$78!)#$!7*,(&')3*+!53-!.&7)!*%$+3+/'!5+.!)#$!$F#5&')!
gas ducting after a longer period of non-use and clean
them if necessary
To Next Page
Loading...
Need help?
General
