NOTE: If installing light on drywall and a ceiling joist cannot be located, use drywall anchors provided. No pilot hole
is required for drywall anchors.
1. Drill pilot holes 6-1/8″ (15.6 cm) apart if mounting to joist. OR Screw in drywall anchors 6-1/8″ (15.6 cm) apart if
mounting to drywall.
2. Determine the length of power cord needed to reach the nearest outlet. Wind any excess cord around cord
retainer on the top side of the light base. Route the cord through the channel so the light mounts flush.
3. Open the light lens.
4. Mount the light with the screws provided.
5. Close the light lens.
6. Plug in the light to the outlet. NOTE: The LED light is very bright and will blink while programming. DO NOT
stare at the light while on a ladder.
Maintenance
Unplug the light before cleaning.
Use a lightly dampened cloth for cleaning.
DO NOT use liquid cleaners on the light lens.
Operation of this equipment is subject to the following two conditions: (1) This equipment or device may not
cause harmful interference, and (2) This equipment or device must accept any interference, including that which
may cause undesired operation.
To Next Page
Loading...
