Champion Global Power Equipment 100519 User Manual (English)

Questions and Answers:

A
Andrea AndersonJul 28, 2025
What to do if my Champion Global Power Equipment 100519 Inverter engine shuts down?
- W
  wrightjennyJul 28, 2025
  If your Champion Global Power Equipment Inverter engine shuts down during operation, consider the following: * **Fuel Level:** Ensure that the fuel tank is adequately filled. * **Oil Level:** Check the oil level and fill the crankcase to the proper level. Also, make sure the generator is placed on a flat, level surface. * **Spark Arrestor:** A clogged spark arrestor can cause shutdowns. Clean the spark arrestor.
J
jacksonchristianAug 2, 2025
Why is my Champion Global Power Equipment 100519 not supplying enough power?
- A
  Anthony HernandezAug 2, 2025
  If your Champion Global Power Equipment Inverter isn't supplying enough power or is overheating, it could be due to these reasons: * **Overload:** The generator might be overloaded. Review the load and adjust accordingly. * **Air Filter:** A dirty air filter can cause issues. Clean or replace the air filter. * **Choke Position:** Ensure the choke is in the correct position. Move it until it stops under the RUN position or push it in completely.
B
Beverly WalkerAug 7, 2025
How to fix a Champion Global Power Equipment Inverter engine that runs roughly?
- V
  Vanessa GarciaAug 7, 2025
  If your Champion Global Power Equipment Inverter engine starts but runs roughly, try these solutions: * **Choke Position:** Adjust the choke to the correct position (RUN) by moving it until it stops or pushing it in completely. * **Air Filter:** Clean or replace the air filter if it's dirty. * **Fuel Valve:** Clean the fuel valve if it's dirty. * **Spark Arrestor:** Clean the spark arrestor.
P
Paula SanchezAug 12, 2025
What to do if Champion Global Power Equipment 100519 Inverter engine runs but has no AC output?
- B
  Brian ReedAug 12, 2025
  If your Champion Global Power Equipment Inverter's engine is running but there's no AC output, check the following: * **Cord Connections:** Ensure all cord connections are secure. * **Circuit Breaker:** Reset the circuit breaker if it's open. * **Wiring:** Inspect and tighten any loose wiring connections. * **GFCI:** Reset GFCI receptacle breakers by pushing the TEST and RESET buttons until the green LED illuminates. * **Other issues:** Contact the help line.
Z
Zachary RodriguezAug 17, 2025
Why does the circuit breaker keep tripping on my Champion Global Power Equipment Inverter?
- A
  Angel MillsAug 17, 2025
  If the circuit breaker on your Champion Global Power Equipment Inverter is tripping repeatedly, here’s what you should do: * **Overload:** The inverter may be overloaded. Reduce the load by disconnecting some devices. * **Faulty Cords/Devices:** Check power cords and connected devices for damage, bare wires, or fraying. Replace any defective items. * **Overheating:** If the circuit breaker is still too hot, let the unit sit for 5 minutes to cool down.

Champion Global Power Equipment 100519 Specifications

General

Rated AC Voltage	120
Rated AC Frequency	60Hz
Fuel Type	Gasoline
Weight	83.8 lb
DC Output	12V 8A
Noise Level	58 dB
Peak Power	6250W
Outlets	Two 120V 20A Household (5-20R)
Dimensions	20.5 x 11.4 x 17.9 inches