Installation
VHR Cold Water Connection
Hot Water Connection- DH6000, DH6000T
Standard and VHR
CAUTION: To prevent damage to the dishwasher supply valves, the installing
plumber must thoroughly ush debris from the water supply line before connecting
it to the dishwasher. Damage caused by improper installation is not covered by the
limited warranty.
COLD
WATER
HOT
WATER
MINIMUM 3/4" NPT HOT WATER SUPPLY
Minimum/Maximum Incoming
Temperature
55-75º/13-24ºC
Minimum Incoming Supply
Flowing Pressure
46-50 PSI
Minimum/Maximum Operating
Flowing Pressure
16 PSI
DH6000-VHR, DH6000T-VHR
Minimum/Maximum Incoming
Temperature
110-140º/43-60ºC
Minimum Incoming Supply
Flowing Pressure
45 PSI/310kPa
Minimum/Maximum Operating
Flowing Pressure
16 PSI
• Water hardness of 3 Grains/US Gal. - 0.83 Imp. Gal - 5.3 mg/L or less.
• Install a 3/4" NPT or larger full port shut-o valve in the water supple line
as close to the dishwasher as a possible for servicing.
5
MINIMUM 3/4" NPT COLD WATER SUPPLY
To Next Page
Loading...
Need help?
General
