Chandler 543 - Page 3

MECHANICS INSTRUCTIONS
THREADING DIAGRAM
:.. .....
INSTRUCTIONS FOR THREADING
Facing the Machine as shown in the
illustration, proceed as follows:
1 From Spool
A, pass thread thru Spool Stand Arm B.
2
Then forward thru Rear Guide Pin ·C.
3 Slide thread between Rear Tension Disc D on the left hand side
of Tension Post E, then to the right hand side of Pin F as
above in detailed view.
4
Repeat step number 3 for Front Tension.
5 Pass thread forward t·hru hole in Thread Slack Pull-of£ Lever G,
Front Guide Pin H and Thread Guide I in top of Face Plate.
6 Slide thread into slot J and down to the right of Pin K.
7 Pass down and around Roller in Lower Guide Plate L.
8 Insert thru Needle Bar Take-up M (left to right).
9
Thread under Tension Disc Face Plate N.
10 Catch thread in Needle Bar Thread Guide 0 and pass it thru the
eye of the Needle from front to back. (For all models having
Needle Bar Thread Guide)
~--------------~CHANDLER~--------------~
CHANDLERl
From the library of: Superior Sewing Machine & Supply LLC