Intelect® RPW
SAFETY INSTRUCTIONS
15
Do not connect the unit to the Mains Power Supply until the
following requirements have been met:
• Before putting the unit into operation, check to make sure
that the handset connection cable and the transmitters are
undamaged and have been connected correctly to the unit.
• Clean and disinfect the unit only when the Mains Power
Supply is deactivated (power switch off, power plug
disconnected).
• Clean and disinfect the unit only by means of disinfection by
wiping. Disinfecting by spraying can damage the unit due to
penetrating moisture.
• Never clean the unit with abrasives, disinfectants, or solvents
that could scratch the housing or damage the unit.
• Never perform unauthorized service work. All service work
must be performed only by service technicians who have
been authorized by the manufacturer.
PROTECTION OF THE UNIT CONTINUED
To Next Page
Loading...
Need help?
General
