72
CHAP. XVII Camper A CLASS
n DRAINING OF DRINKING WATER
To drain hot and cold water, proceed as follows:
1 - Turn the pump off on the control panel.
2 - Empty the reservoir by opening the cap(s). A valve
is located inside the vehicle close to the reservoir.
3 - Open the water heater faucet (see the chapter
on WATER HEATER/HEATING)
4 - When the reservoir and the water heater are empty, open the
faucets and pump starter for a few seconds.
5 - When the circuit is empty, close the drinking water reservoir
valve and the heater drain valve.
n DRAINING OF WASTE WATER
-
All waste water (washbasin, sink and shower) is collected in a
rigid tank with a capacity of around 100 liters located under the
vehicle floor.
- A sensor signals when the tank is full, the warning light comes
on and there is a beeping noise on the control panel.
- Reservoirs are emptied using a manual valve for wastewater and
by removing a stopper for the clean water containers located on
the side of and under the vehicle
.
WARNING:
If you use your camper in very cold weather, the MANUFACTURER cannot guarantee that the waste water circuit will be fully freeze
safe. Remember that insulation without a heat supply only delays thermal exchange.
IMPORTANT: It is strongly recommended to always empty water in the circuit, tank and water heater when there is a risk of freezing
and your camper is not being used.
To Next Page
