9
4. Fill the water tank with no more than 14 oz of filtered water and no
less than 6 oz.
NOTE: Water should not pass the 14-oz measurement marking located
on the back left wall of the water tank.
5. Push the lid of the InstaCoffee down until it clicks into place.
6. Place a mug or travel cup large enough to hold at least 14 oz of water
onto the rubber trivet located on the base of the InstaCoffee. Double
check that mug is securely situated.
7. Press the brew button. The brew indicator light will illuminate in red
while the InstaCoffee heats up and dispenses the hot coffee.
NOTE: During the last 10 seconds of the brew cycle, you will hear a
whirring sound. This is a normal part of the brewing cycle.
8. After the indicator light has turned off completely, carefully remove
filled mug from base.
CAUTION: Mug and coffee will be very hot.
9. Allow InstaCoffee to cool. Once cool, discard the used coffee grinds
and clean as directed in Cleaning and Maintenance.
OPERATING INSTRUCTIONS
To Next Page
Loading...
Need help?
General