17
CLEANING AND MAINTENANCE
HOW TO USE THE SELF-CLEANING FEATURE
The ice maker is equipped with a self-cleaning feature to ensure easy and complete
sanitation and should be used at least once per week.
1. To activate the self-cleaning function, the ice maker must be in standby mode.
Enter standby mode by doing one of the following: 1) If the ice maker is unplugged,
plug in the unit; the ICE indicator light will blink indicating it’s in standby mode;
2) If the ice maker is plugged in and on (or in the middle of) an ice-making cycle,
press STOP, and the ICE indicator light will change from solid to blinking. This
means the ice maker has entered standby mode.
2. If necessary, remove any ice and empty the water reservoir using the drain tubes.
Replace the drain tubes and ensure they are closed properly.
3. Fill the water reservoir with clean water.
4. Press the HOLD TO CLEAN button for about three seconds until the CLEAN
indicator light illuminates. The cleaning function takes approximately 8 minutes,
after which the unit will return to standby mode.
5. Empty the water reservoir using the drain tubes. Follow the instructions to begin
making ice or dry completely for storage.
5. To clean the ice maker’s internal parts, follow the instructions below to activate the self-
cleaning feature when needed.
6. Always empty the water reservoir (see drawing on p. 16) and dry completely for storage
if the ice maker will not be used for an extended period of time. This will prevent mold
and mildew from forming.
To Next Page
Loading...
