Back-up Lamp
1. Open the trunk. The back-up lamp bulbs are in the
rear of the trunk lid.
2.
Press
the
tab on the
socket, turn the socket to
the left and pull it out.
3.
To
remove the bulb, pull it out of the socket.
Do
not
4.
Push the new bulb into the socket.
twist the bulb.
5.
Reverse Steps
1
through
3
to
replace the socket.
Dome
Lamp
1.
Grasp the front and rear center of
the
dome lamp cover
at
the
same
time. Then squeeze and pull downward.
(To
help pry the sides loose, a flat-blade screwdriver
may be used as
an
aid during
hs
procedure).
I.
Remove the old bulb from the small prongs
extending
from
the dome lamp base plate; hook the
new bulb onto the prongs.
3.
To replace
the
bulb cover, center it over the base
plate, making sure both the cover and the base plate
line up properly. Snap the cover firmly into place.
For any bulb changing procedure not listed in
this
section,
contact your Chevrolet dealer service department.
To Next Page
Loading...
