2-69
Canadian Programming
Canadian Owners: During programming, the
hand
-held transmitter may automatically stop
transmitting after two seconds. In this case, you
should press and hold the HomeLink button
(see Steps 2 and 3 under Programming the HomeLink
Transmitter) while you press and repress (cycle) your
hand
-held transmitter every two seconds until
HomeLink is trained
Operating the HomeLink Transmitter
Press and hold the appropriate button on HomeLInk for
at least a half of a second. the indicator light will come
on while the signal is being transmitted.
Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons on HomeLink until the indicator
light begins to flash (approximately 20 seconds).
Release both buttons.
Resetting Defaults
To reset HomeLInk to default settings, hold down the
two outside buttons on HomeLink until the indicator
light begins to flash (approximately 20 seconds).
Continue to hold the buttons until the HomeLink
indicator light turns off and then release both buttons.
Accessories
Accessories for HomeLink are available from the
manufacturer. If you would like additional information
contact the manufacturer at 1-800-355-3515, or
on the internet at www.homelink.com.
To Next Page
Loading...
