Finding a Station
AM
FM:
Press this button to switch the display between
time and radio station frequency. Time display is
available with the ignition turned
off.
TUNE:
Turn this knob to tune in radio stations.
4
SEEK
D
:
Press the right or the left arrow to seek
to the next or to the previous station and stay there.
To scan stations, press and hold one of the SEEK
arrows for two seconds until you hear a beep. The radio
will
go
to
a
station, play for a few seconds and flash
the station frequency, then go on to the next station.
Press one of the SEEK arrows again to stop scanning.
To scan preset stations, press and hold one of the
SEEK arrows for more than four seconds until you hear
two beeps. The radio will go to the first preset station
stored on the pushbuttons, play for a few seconds
and flash the station frequency, then go on to the next
preset station. Press one of the SEEK arrows again
to stop scanning presets.
Setting Preset Stations
The six numbered pushbuttons let you return to
your favorite stations. You can set up to 18 stations
(six AM, six FM1 and six FM2) by performing the
following steps:
1. Turn the radio on.
2. Press AM FM to select AM, FM1 or FM2.
3.
Tune in the desired station.
4.
Press and hold one of the six numbered
pushbuttons until you hear a beep. Whenever you
press that numbered pushbutton, the station
you set will return.
5.
Repeat the steps for each pushbutton.
This radio will seek and scan only to stations that are in
the selected band and only to those with a strong
signal.
3-72
To Next Page
Loading...
Need help?
General
